Reply To: Run Failure: "Sequence contains no elements"

Deliver geospatial models direct to decision makers with SyncroSim › Forums › ST-Sim & State-and-Transition Simulation Models › Run Failure: "Sequence contains no elements" › Reply To: Run Failure: "Sequence contains no elements"

October 23, 2013 at 6:40 pm #1842
leonardo-fridleonardo-frid
Keymaster

Hi Brian,

 

This is a known bug in version 1.4 of ST-Sim associated with prioritizing large patche edges for transitions when area targets are used.  The crash is incosistent and does not always occur; but it does often.  It will be fixed in the upcoming version (1.5) of ST-Sim.  We hope to get a release out by early November.

 

Regards,

Leonardo