Calculated Values

Deliver geospatial models direct to decision makers with SyncroSim › Forums › SyncroSim – General Questions and Answers › Calculated Values

Tagged: ,

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • June 23, 2019 at 4:10 am #7184
    lihanwei007lihanwei007
    Participant

    I want to run my simulation by SyncroSim version 2.0.42. About setting “Initial Conditions”-“Spatial”-“Calculated Values”, the “cell size” refers to raster area or raster resolution? And what the unit is？

    Thanks for your time,
    Hanwei

    June 23, 2019 at 10:38 pm #7190
    leonardo-fridleonardo-frid
    Keymaster

    The cell size calculation is for area and is in the “amount units” that you define under the “Project Properties | Terminology Tab”.
    For some raster projections, SyncroSim may not be able to calculate the cell size in which case you can use the the “Override” checkbox.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.