Transition Attribute Targets

[ahunt]

I have set-up transition attribute targets by strata (3) and transition attribute type, leaving iterations and timesteps blank. Simulations are resulting in over double the annual targets, and I can’t figure out why. The probabilities for all transitions with transition attribute values are the same (at 0.01), and none of these transitions belong to more than one transition simulation group. Since the transition probabilities do not differ by stratum, I have not specified transition probabilities by strata in the transitions table, although my targets are specified by stratum. Any ideas why my transition attribute values don’t seem to be constrained by my targets? I am running Syncrosim Studio 3.0.9. Thanks.

[leonardo-frid]

Hi Ayn,

One thing to double check is whether a single transition type/group is associated with more than one transition attribute type. If this is the case, then targets may be in conflict with each other. Otherwise, it would be helpful for me to take a look at your library to see if I can diagnose the problem.

Regards,
Leonardo

[ahunt]

That is likely it. Thanks.

[Author]

Posts