Menu Close

Where do MCM file locations get entered in Path 4.0.10?

Syncrosim › Forums › ST-Sim & State-and-Transition Simulation Models › Where do MCM file locations get entered in Path 4.0.10?

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 29, 2012 at 4:11 pm #1626
    ashliskyashlisky
    Participant

    I can’t seem to find in Path 4.1.10 where to enter the location of my MCM file. Thanks.

    February 29, 2012 at 5:55 pm #1789
    leonardo-fridleonardo-frid
    Keymaster

    Hi Ayn,

    Path 4.0.10 no longer runs VDDT as the simulation engine and so it does not read MCM files. To use temporal multipliers you need to use the Transition Multiplier Property on the Advanced Scenario Property tab. Using this property you can specify transition multipliers by stratum, iteration, timestep, and transition type. The first three of these inputs are optional and if left blank will apply to all possible cases.

    Cheers,
    Leonardo

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.