Menu Close

Reply To: Where do MCM file locations get entered in Path 4.0.10?

Syncrosim › Forums › ST-Sim & State-and-Transition Simulation Models › Where do MCM file locations get entered in Path 4.0.10? › Reply To: Where do MCM file locations get entered in Path 4.0.10?

February 29, 2012 at 5:55 pm #1789
Leonardo FridLeonardo Frid
Keymaster

Hi Ayn,

Path 4.0.10 no longer runs VDDT as the simulation engine and so it does not read MCM files. To use temporal multipliers you need to use the Transition Multiplier Property on the Advanced Scenario Property tab. Using this property you can specify transition multipliers by stratum, iteration, timestep, and transition type. The first three of these inputs are optional and if left blank will apply to all possible cases.

Cheers,
Leonardo