Model failure

Deliver geospatial models direct to decision makers with SyncroSim › Forums › ST-Sim & State-and-Transition Simulation Models › Model failure

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • May 2, 2017 at 4:04 pm #4377
    aregerareger
    Participant

    The model is supposed to be running 10 iterations 750 time steps. The disk has plenty of space. The model has run for 4 to 7 iterations before failing for now apparent reason. I am trying to eliminate any external forces that might be sabotaging the run. (anti-virus programs, agency software updates, etc). Any other ideas that might be causing the failure.

    May 8, 2017 at 10:06 am #4387
    colin-danielcolin-daniel
    Keymaster

    It could be a RAM issue. The amount of RAM required depends on the specifics of your model run, so we would need to look at the specifics of your run to determine the cause.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.